Seven Segment Display and Keypad

The Seven Segment Display and its TM1637 controller

There is a nice and simple seven segment display controlled by a TM1637 controller, which can be used e.g. as a clock display. It provides 4 digits and a colon dividing digits 1 and 2 from digits 3 and 4, such that the first two digits can be used to display hours, the last two digits to display minutes and the colon can be set blinking at a 1 Hz rate. Of course you can also use it for other purposes like displaying the voltage values of a voltmeter.

As can be seen from the back view of the module, interfacing to the ESP32 is pretty simple. Here are the connections I use:

Pins on display module	Pins on ESP32
CLK	D1: GPIO 22
DIO	D2: GPIO 21
VCC	3.3V
GND	GND

The data sheet for the TM1637 controller can be found at https://www.mcielectronics.cl/website_MCI/static/documents/Datasheet_TM1637.pdf.

The TM1637 uses a proprietary 2-wire serial protocol with a data line (dio) and a clock line.

Exercise 1:

Carefully read the data sheet.

Write a driver implementing the serial protocol. Implement he driver as class TM1637 with the following methods:

• start_transfer: implements the start sequence (dio going low when clk is high)
• stop transfer: implements the "end of transfer" sequence (dio going high when clk is high)
• write_bit: write a single bit: with clk low, set dio to the bit value, then send a pulse (high followed by low) on the clk pin
• write byte: send 8 bits. After the eights bit, check the acknowledge signal. Switch dio to input, check acq, switch dio back to output after the falling edge of the nineth clock pulse
• display on: switch the display on: start_transfer, send display_on command, stop transfer
• create a table with the led setting of the seven segments. dp means decimal point, which is only used on the second digit, where it controls the following colon.

      A
     ---
  F |   | B      dp,g,f,e, d,c,b,a: the data byte
     -G-
  E |   | C
     ---
      D

• write_digit(digit_num,digit,colon=False): sets digit number digit_num to the value digit. If colon is true and the digit number is 1 (start counting from zero) the switch the colon on.
• clear_digits(colon=False): clear all digits. Only the colon stays on if colon == True
• write_hex(number,colon=False): write a hex number to the display
• write_dec(number,colon=False): write a decimal number to the display.

Write a test routine that exercises all the above methods

Exercise 2:

Read the current time from the ntp and implement a clock displaying hours and minutes. Make the colon blink at a 1 Hz rate.

The Keypad

The keypad has a total of 16 switches. These are connected to 8 pins organized as 4 rows and 4 columns.

The job will be to find out which column makes a connection to which row in order to find out which switch is closed. This can be done by connecting e.g. the 4 row pins to GPIO outputs and the 4 column pins to GPIO inputs with pull-ups.

Set the first row pin to low and check on each column pin if you read a zero. If you do, you have found the switch closed. If not, continue the same procedure on the other row pins.

Comments