(r3) MinimalLectures < AFNOG

Tags: view all tags

---+ Lecture notes
---++ Summary:
   * Introduction (this page)
   * [[Communicating with the ESP32]]
   * [[First Python Programs]]
   * [[Modules and Timing]]
---++ Introduction

During the exercise sessions, we will first develop a program that lights the user programmable LED on the CPU card. This displays a binary signal, which can only be high or low. The exercise therefore demonstrates how to output a signal and how to control a single digital signal line.

<img alt="esp32V1.png" height="410" src="%ATTACHURL%/esp32V1.png" title="esp32V1.png" width="313" />

On the bottom right of the photo, you see 2 LEDs. The lower one marked ON (upside down) shows if power is supplied to the board, the upper one is user programmable.

As a second exercise we will read a digital actuator, namely a simple push button switch, and we will display its current value (_pushed_ or <i>released) </i>on the PC screen. This exercise therefore demonstrates how to acquire the state of a digital signal. After that, we may switch the LED on, when the button is pressed, and switch it off, when the button is released, thus combining the acquisition of a digital sensor with the display of its state.

<img alt="pushbutton.png" height="344" src="%ATTACHURL%/pushbutton.png" title="pushbutton.png" width="357" />

A slightly more complex program will allow us to read the signal level generated by an analogue sensor (our potentiometer) and display the signal level on the 7 LED rgb (red, green, blue) display. For this to work, we must first understand how to connect and read the analogue signal using the <b>A</b>nalogue to <b>D</b>igital <b>C</b>onverter (ADC). Then we must find out how an LED on the LED ring can be lit and how to select its color. Finally, we can again combine the two functions into a single program. This will read the signal level from the potentiometer and light one of the LEDs on the LED ring. For lowest signal levels, the top LED is lit in blue (which often represents a cold or low value). If the value is a bit higher, then the second LED is activated in cyan, After that we go clockwise using the colors (blue, cyan, green, yellow, magenta, red, white) where white will be displayed for the highest signal level on the center LED.

| <img alt="slider.png" height="384" src="%ATTACHURL%/slider.png" title="slider.png" width="467" /> | <img alt="leds.png" height="440" src="%ATTACHURL%/leds.png" title="leds.png" width="444" /> |
Now that we know what we have to do, let's go for it! [[Communicating with the ESP32]]

- - %USERSIG{UliRaich - 2022-10-14}%

---++ Comments

%COMMENT%

Attachments

Topic attachments
I	Attachment	History	Action	Size	Date	Who
png	esp32V1.png	r1	manage	240.5 K	2022-10-14 - 15:12	UliRaich
png	leds.png	r1	manage	292.6 K	2022-10-14 - 15:39	UliRaich
png	pushbutton.png	r1	manage	154.5 K	2022-10-14 - 15:12	UliRaich
png	slider.png	r1	manage	152.9 K	2022-10-14 - 15:39	UliRaich

Topic revision: r3 - 2022-10-15 - UliRaich