The OLED shield

This shield features a 64x48 pixel OLED display. We would normally not connect it as IoT sensor but it comes it handy to display the state of out WeMos sensor node, especially when running from battery and without a serial connector to the PC.

Programming the shield

The shield uses an SSD1306 OLED dot matrix controller which is accessed through the I2C bus. In order to see if we can access the chip we can first run a little program scanning the I2C bus and showing all uses I2C addresses:

This shows us that the module must be accesses on I2C address 0x3c. The code of the i2c scanner can be found here:

https://iotworkshop.africa/pub/AFNOG/OledShield/i2cScan.py.txt

-- Uli Raich - 2019-03-22

Comments